Performance introduction of roof tile equipment
Roof tile equipment has the characteristics of environmental protection, lightweight, light weight and beauty, and zero loss in the process of installation, and can be recycled. When using roof tile production equipment, we should understand its following performance:
Performance of roof tile equipment
1. Conducive to building energy saving
The roof tile production equipment can speed up the construction of the project, reduce the input of roof support materials, and save the building cost for real estate developers. The raw materials used in the production are mostly industrial wastes, which can not only reduce industrial pollution, but also "turn waste into treasure". In addition to using sand as fine aggregate, the molded color cement tile can also use industrial waste residue, such as fly ash of power plant, The slag of steel plant can be used as fine aggregate after wet milling and activation process, and its mixing amount can reach about 60%, so as to save resources, save land and protect environment
2. Room temperature molding
Due to the high pressure molding with 150t press, it is not necessary to maintain the high temperature sintering steam. Generally, the outdoor temperature is above 20 ° and the demoulding can be carried out in 8 hours. The product has accurate dimensions, neat edges and corners, and reliable biting.
3. Various tile types
The color is colorful and colorful, durable and has good decoration effect.
4. The tile is light
The tile is large in size and light in unit weight. Its general size is 428 mm × 336 mm. The weight of a single piece is 3.6-4 kg, and the weight per square meter is 36-40 kg. The clay fired colored tile and glazed tile are about 16 pieces per square meter, 3kg per piece, 45-51kg per square meter.
5. Structural diversification
It can avoid the single structure of the traditional rolling forming process, and the higher part of the tile head plays the role of water retaining. Even if it is used in the sloping roof below 10 degrees, there is no rainwater backflow phenomenon.
6. Reliable lapping
The arc-shaped outflow of the lower part is more smooth, and the protruding part on the back can be overlapped with the head of another tile. When the roof slope is not large, it is unnecessary to hang tile nails.
The above is about the performance of roof tile equipment