How to install the back tile of resin tile production line

- Aug 05, 2020-

Resin tile production line is a new generation of light and environmental protection building materials advocated by the state and promoted. The products are environmentally friendly, energy-saving and renewable. Its unique performance advantages have won the general attention and recognition of the construction industry, and the product market is very broad. The new building materials developed by high-tech chemical technology have many excellent characteristics, such as light weight, high strength, waterproof and moisture-proof, anti-corrosion and flame-retardant, sound insulation and heat insulation. They are widely used in the Development Zone, such as flat to slope, agricultural markets, shopping malls, residential areas, high-grade villas, awnings, awnings, antique buildings, etc.

1551688572911473

Hangzhou Polytech gum Machinery Co., Ltd. is a professional manufacturer of resin tile production line equipment flat to slope tile glazed tile production line. The production line is composed of extruder, die and molding auxiliary unit. It can continuously produce PVC single layer or PVC / PMMA and PVC / ASA composite plastic glazed tile. This line has the characteristics of high production efficiency, reasonable and compact structure, convenient use and maintenance, and long service life.

1551688579647959

Hangzhou Polytech Plastic Machinery Co., Ltd. its resin tile production line equipment for the majority of resin tile production line manufacturers in the sale and installation of resin tile production line put forward some valuable opinions, resin tile production line as a light building material, installation is more convenient and fast, but construction must also strictly abide by the relevant installation guidelines, in order to avoid the late housing need not The maintenance is troublesome. During the installation process, many customers have many problems with the installation of accessories. The following editor from Hangzhou baolitai Plastic Machinery Co., Ltd. will introduce the installation methods of some main accessories in detail

1. There are bearing joints on both sides of the main ridge tile. When the two pieces are overlapped, the big head of the upper ridge tile will buckle the small head of the lower ridge tile.

2. The installation of the main ridge tile should start from one side. The large head part should be cut off in the first piece. The two wings of the main ridge tile should be close to the main slope tile, and the ridge tile wave should be consistent with the main slope tile. Use special fastening kit to fix the ridge tile with the main tile and purlin. There are 2-3 fixed points, and the laying direction is the same as that of the main tile, and the surplus part of the last sheet should be cut off.

3. There are bearing joints on both sides of the inclined ridge tile. When two pieces are overlapped, the big head of the upper ridge tile will buckle the small head of the lower ridge tile.

4. The center line of the inclined ridge tile is aligned with the inclined eaves. The special fastening kit is used to connect and fix the inclined ridge tile and the tile at the protruding part of the tile. There are 3 fixed points and the laying direction is from bottom to top.

5. Cut off the surplus part of the last oblique ridge tile.

6. The inclined ridge head shall be installed at the bottom of the inclined ridge tile, extending from 100 mm to 200 mm.

7. The head of oblique ridge tile of resin tile production line is fixed with inclined ridge tile with special rivets, with 2 fixing points.